SETTING AUTOMATIC AND MECHANICAL WATCHES

The Automatic Self-winding and Mechanical Watches are not operated by battery.

AUTOMATIC WATCHES
Your daily activity should wind the watch sufficiently to build up a power reserve and keep the watch running at night when it is not being worn. On models which can also be hand wound occasional supplementary manual winding may be necessary. It is suggested that your mechanical watch be cleaned and oiled periodically to ensure optimum performance. As this is a mechanical watch, quartz watch accuracy cannot be expected.

MECHANICAL WATCHES
To fully hand wind the watch turn the crown clockwise around 15 times. Once you meet resistance stop winding. Daily winding is required to keep the watch running, stop winding as soon as resistance if felt to avoid over winding.

SETTING YOUR WATCH

DISPLAY
*Date & Day of the week position may be located at different position depends on models.

SETTING THE TIME
Pull the crown out to the 2nd position.
Turn the crown to set hour and minute hands.
When the crown is pushed back to the normal position,
second hand begins to run.

SETTING THE DATE
Pull the crown out to the 1st position.
Turn the crown counter-clockwise to set the date.
*If the date is set between the hours of around 9:00 PM and 1:00 AM, the date may not change on the following day.
After the date has been set, push the crown back to the normal position.

SETTING THE DATE OF THE WEEK
Pull the crown out to the 1st position.
Turn the crown clockwise to set the day of the week.
*If the date is set between the hours of around 9:00 PM and 1:00 AM,
the day of the week may not change the following day.
After the day of the week has been set, push the crown back to the normal position.